Start-Up Procedure and Diagnosis Menu
System Diagnosis ModeStart-up procedure and Diagnosis Menu
There are two ways to enter the diagnostic mode:
1. Connect the SCS service connector to the navigation service connector located in the trunk. Turn the ignition switch to the ON (II) position. The display will go directly to the diagnostic menu screen.
NOTE: When finished troubleshooting, make sure to remove the SCS service connector.
2. Turn the ignition switch ON (II).
Use the navigation display hard buttons as described below:
a. If the battery has not been disconnected, then press and hold the 3 buttons (Menu, Map/Guide, and Cancel), and keep them pressed for about 5 seconds. The display screen will go directly to the "Select Diagnosis Items" menu.
b. If the battery was disconnected and reconnected prior to this test, hold down the Menu and Zoom Out buttons at the "Code" or "GPS Acquire" screen. The display will go to the "Navi System Link" screen. Push the joystick to go to the "Functional Setup menu," then touch the Return icon to get to the "Select Diagnosis Items" menu.
NOTE: This only allows access to the diagnostic screens. All other navigation functions are disabled.
3. After the display changes to the Select Diagnosis Items menu, select the item you want to check and the diagnostic will start. To return to the previous screen, select "RETURN".
- Navi System (Link)
- F-CAN (System link)
- B-CAN (System link)
- Monitor Check
- Unit Check
- Car Status
- GPS Information
- Yaw Rate
- Tire Calibrate
- Functional Setup
- Version