Console Panel Removal/Installation

Center Console Panel Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the front seat, dashboard and related parts.

1. Move both front seats all the way back.
2. Remove these items:
- Center console rear section
- Dashboard lower cover
- Glove box housing




3. Remove the trim (A).




4. M/T model: Remove the insert panel (A) to release the hooks (B).




5. Remove the screws (A, B), and detach the clips (C), then remove the driver's console side cover (D) and passenger's console side cover (E).




6. Pull the center console panel (A) to release the pin (B), and disconnect the accessory power socket connector (C) and seat heater switch connectors (D).




7. Turn the center console panel (A) then lift it up and away from the dashboard.
8. Install the console panel in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.
- Replace any damaged clips.
- Push the clips and hooks into place securely.