Center Upper Panel

Center Upper Panel Removal/Installation

Special Tools Required
Vent panel puller O7AAC-S3VA100

NOTE: Take care not to scratch the dashboard and related parts.




1. Position a vent panel puller (A) as shown on the upper panel (B).




2. Carefully pull one side of upper panel (A) partially out to release clips (B, C, D), then do the same on the other side. Disconnect the hazard warning switch connector (E) and audio-HVAC subdisplay clock connector (F), then remove the upper panel.
3. Install the panel in the reverse order of removal, and make sure each connector is plugged in properly.