Front Passenger's Airbag Replacement
Front Passenger's Airbag ReplacementRemoval
NOTE: If the front passenger's airbag has been deployed, refer to the install for after a collision where the front passenger's airbag deployed.
1. Disconnect the battery negative cable and wait at least 3 minutes before beginning work.
2. Remove these items:
- Glove box housing
- Front passenger's air conditioning duct
- Passenger's dashboard trim
3. Disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness.
4. Remove the mounting nuts (A) from the bracket. Remove the front passenger's airbag (B).
Installation
1. Place the new front passenger's airbag (A) into the bracket. Tighten the front passenger's airbag mounting nuts (B).
2. Connect the front passenger's airbag 4P connector (A) to the dashboard wire harness, then reinstall the glove box.
3. Reconnect the battery negative cable.
4. Connect the HDS and erase the DTCs.
5. After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
Installation after a collision where the front passenger's airbag deployed
1. Disconnect the battery negative cable and wait at least 3 minutes before beginning work.
2. Remove the dashboard assembly out of the vehicle.
3. Remove the center upper panel from the dashboard.
4. Install the center upper panel to the dashboard.
5. With the dashboard upside-down, remove the anti-contamination cover (A) from the new dashboard upper panel.
6. Place the new front passenger's airbag into the bracket. Tighten the front passenger's airbag mounting nuts (A).
NOTE:
- Be sure to install the front passenger's airbag so they do not interfere with other parts.
- When you install the front passenger's airbag, be careful not to damage the bag.
- Be sure to keep the new airbag clean and do not unfold or tamper with the cloth cover on the airbag,
7. Install the dashboard assembly in the vehicle.
8. Connect the front passenger's airbag 4P connector (A) to the dashboard wire harness, then reinstall all removed parts in the reverse order that they were removed.
9. Reconnect the battery negative cable.
10. Connect the HDS and erase the DTCs.
11. After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.