Output Shaft (Countershaft) Speed Sensor Replacement
Output Shaft (Countershaft) Speed Sensor Replacement1. Make sure you have the anti-theft codes for the radio and navigation system, and write down the audio presets.
2. Remove the left side engine compartment cover.
3. Make sure the ignition switch is OFF. Remove the battery negative terminal, then remove the battery positive terminal.
4. Remove the battery hold-down bracket, then remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Disconnect the output shaft (countershaft) speed sensor connector.
7. Remove the bolt securing the output shaft (countershaft) speed sensor (A) from the transmission housing.
8. Install the new O-ring (B) on the output shaft (countershaft) speed sensor, then install the output shaft (countershaft) speed sensor in the transmission housing. Do not allow dust or foreign particles to enter the transmission.
9. Check for corrosion, dirt, and oil, then connect the connector securely.
10. Install the air intake duct and air cleaner housing.
11. Install the battery tray, battery, and battery hold down bracket.
12. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
13. Install the left side engine compartment cover.
14. Enter the anti-theft codes for the radio and navigation system, then enter the audio presets, and set the clock.