B1229
DTC B1229 or TS sensor open is indicated.:An Open in the Sunlight Sensor Circuit
1. Clear the DTC with the HDS.
2. Operate the climate control system in several modes.
3. Check for DTCs using the HDS or self-diagnostic.
Is DTC B1229 or TS sensor open indicated?
YES - Go to step 4.
NO- Intermittent failure, check for loose wires or poor connections on the sunlight sensor circuit.
4. Turn the ignition switch OFF.
5. Disconnect the sunlight sensor 5P connector.
6. Disconnect the climate control unit 40P connector.
7. Check for continuity between the No. 18 terminal of the climate control unit 40P connector and the No. 4 terminal of the sunlight sensor 5P connector.
Is there continuity?
YES - Go to step 8.
NO- Repair open in the wire between the climate control unit and the sunlight sensor.
8. Check for continuity between the No. 33 terminal of the climate control unit 40P connector and the No. 2 terminal of the sunlight sensor 5P connector.
Is there continuity?
YES - Go to step 9.
NO - Repair open in the wire between the climate control unit and the sunlight sensor.
9. Reconnect the sunlight sensor 5P connector.
10. Reconnect the climate control unit 40P connector.
11. Test the sunlight sensor.
Is the sunlight sensor OK?
YES - Check for loose wires or poor connections at the climate control unit 40P connector and at the sunlight sensor 5P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit
NO - Replace the sunlight sensor.