B1835

DTC B1835:Tilt/Telescopic Switch Signal Input Error

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test mode A.

1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF and then back ON (II).
3. Operate the tilt/telescopic switch in each direction for more than 3 seconds each.
4. Check for DTCs with the HDS.

Is DTC B1835 indicated?

YES - Go to step 5.

NO - Intermittent failure. The power tilt/telescopic steering system is OK at this time. Check for loose or poor connections at the tilt/telescopic switch connector and at the power tilt/telescopic control unit connector.

5. Turn the ignition switch OFF.
6. Test the tilt/telescopic switch.

Is the switch OK?

YES - Go to step 7.

NO - Replace the switch.

7. Disconnect power tilt/telescopic steering control unit connector A (16P).
8. Disconnect the tilt/telescopic switch 13P connector.




9. Check for continuity between body ground and tilt/telescopic switch 13P connector terminals No. 1, No. 7, and No. 10 individually.

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 10.




10. Check for continuity between power tilt/telescopic steering control unit connector A (16P) terminals No. 7, No. 6, and No. 14 and the tilt/telescopic switch 13P connector terminals No. 1, No. 7, and No. 10 respectively.

Is there continuity?

YES - Replace the power tilt/telescopic steering control unit

NO - Repair an open in the wire.