DTC 44
DTC 44: Cal FL Brake Fluid Pressure Sensor Circuit Open/Short1. Turn the ignition switch ON (II).
2. Clear the DTCs with the HDS.
3. Watch the adaptive cruise control (ACC) indicator.
Does the adaptive cruise control (ACC) indicator stay off?
YES - Intermittent failure. The system is OK at this time. Check for loose or poor connections.
NO - Go to step 4.
4. Check for DTCs with the HDS.
Is DTC 44 indicated?
YES - Go to step 5.
NO - Troubleshoot the indicated DTC(s). If there are no DTCs, the system is OK at this time.
5. Check the left front brake fluid pressure voltage (VPRFL) with the HDS.
Is there about 0.5 V?
YES - Go to step 6.
NO - Go to step 9.
6. Do the brake booster test.
7. Press the brake pedal with about 314 N (32 kgf, 70.6 lbf) pressure.
8. Check the left front brake fluid pressure voltage (VPRFL) with the HDS.
Is there about 2.5 V?
YES - The left front brake fluid pressure signal is OK, check for loose or poor connections. If OK, replace the adaptive cruise control (ACC) unit.
NO - Go to step 9.
9. Turn the ignition switch OFF.
10. Disconnect the 20P connector from the adaptive cruise control (ACC) unit.
11. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 5 terminal and body ground.
Is there continuity?
YES - Repair a short to ground in the wire between the adaptive cruise control (ACC) unit and the left front pressure sensor.
NO - Go to step 12.
12. Disconnect the 3P connector from the left front pressure sensor.
13. Connect the left front pressure sensor 3P connector No. 2 terminal to body ground with a jumper wire.
14. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 5 terminal and body ground.
Is there continuity?
YES - Go to step 15.
NO - Repair an open in the wire between the adaptive cruise control (ACC) unit and the left front pressure sensor.
15. Remove the jumper wire from the left front pressure sensor.
16. Reconnect all connectors.
17. Turn the ignition switch ON (II).
18. Check for voltage between the adaptive cruise control (ACC) unit 20P connector No. 3 and No. 5 terminals.
Is there about 5 V?
YES - Go to step 19.
NO - Check for loose or poor connections. If OK, replace the adaptive cruise control (ACC) unit.
19. Turn the ignition switch OFF.
20. Disconnect the 20P connector from the adaptive cruise control (ACC) unit.
21. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 14 terminal and body ground.
Is there continuity?
YES - Repair a short to ground in the wire between the adaptive cruise control (ACC) unit and the left front pressure sensor.
NO - Go to step 22.
22. Disconnect the 3P connector from the left front pressure sensor.
23. Connect the left front pressure sensor 3P connector No. 3 terminal to body ground with a jumper wire.
24. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 14 terminal and body ground.
Is there continuity?
YES - Go to step 25.
NO - Repair an open in the wire between the adaptive cruise control (ACC) unit and the left front pressure sensor.
25. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 5 terminal and body ground.
Is there continuity?
YES - Repair a short in the wire between the PRESS FL line and VCC line.
NO - Go to step 26.
26. Check for continuity between the adaptive cruise control (ACC) unit 20P connector No. 3 terminal and body ground.
Is there continuity?
YES - Go to step 27.
NO - Repair an open in the wire between the adaptive cruise control (ACC) unit and the left front pressure sensor.
27. Remove the jumper wire from the left front pressure sensor.
28. Reconnect all connectors.
29. Turn the ignition switch ON (II).
30. Check for voltage between the adaptive cruise control (ACC) unit 20P connector No. 3 and No. 14 terminals.
Is there about 0.5 V?
YES - Go to step 31.
NO - Replace the left front pressure sensor.
31. Clear the DTCs with the HDS.
32. Watch the adaptive cruise control (ACC) indicator.
Does the adaptive cruise control (ACC) indicator stay off?
YES - Intermittent failure. The system is OK at this time. Check for loose or poor connections.
NO - Go to step 33.
33. Check for DTCs with the HDS.
Is DTC 44 indicated?
YES - Check for loose or poor connections. If OK, replace the adaptive cruise control (ACC) unit.
NO - Troubleshoot the indicated DTC(s). If there are no DTCs, the system is OK at this time.