P2101
DTC P2101: Throttle Actuator System malfunctionNOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
1. Clear the DTC with the HDS.
2. Do the ETCS TEST in the INSPECTION MENU with the HDS.
3. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P2101 indicated?
YES - Go to step 6.
NO - Go to step 4.
4. Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters:
- ENGINE SPEED
- VSS
- APP SENSOR
5. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P2101 indicated?
YES - Go to step 6.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then clean the throttle body.
6. Turn the ignition switch OFF.
7. Disconnect the intake air duct from the throttle body.
8. Turn the ignition switch ON (II).
9. Clear the DTC with the HDS.
10. Do the ETCS TEST in the INSPECTION MENU with the HDS.
11. Visually check the throttle valve operation.
NOTE: Be careful not to pinch your fingers during the check.
Does the throttle valve operate smoothly?
YES - Clean the throttle body, then go to step 21 and recheck. If DTC P2101 is indicated, go to step 19.
NO - Go to step 12.
12. Turn the ignition switch OFF.
13. Disconnect the throttle body 6P connector.
14. Disconnect the C251 connector (13P) between the PCM subharness and the throttle actuator control module subharness.
15. Connect throttle body 6P connector terminals No. 5 and No. 6 with a jumper wire.
16. Check for continuity between C251 connector (13P) terminals No. 6 and No. 13.
Is there continuity?
YES - Go to step 17.
NO - Repair open in the wire between the throttle body and the C251 connector (motor drive lines), then go to step 21.
17. Disconnect the throttle actuator control module 16P connector.
18. Check for continuity between throttle actuator control module 16P connector terminals No. 1 and No. 8 and C251 connector (13P) terminals No. 6 and No. 13 individually.
Is there continuity?
YES - Substitute a known-good throttle actuator control module, then go to step 21 and recheck. If DTC P2101 is not indicated, replace the original throttle actuator control module, then go to step 21. If DTC P2101 is indicated, go to step 19.
NO - Repair open in the wires between the throttle actuator control module and the C251 connector (motor drive lines), then go to step 21.
19. Turn the ignition switch OFF.
20. Replace the throttle body.
21. Reconnect all connectors.
22. Turn the ignition switch ON (II).
23. Reset the PCM with the HDS.
24. Do the PCM idle learn procedure.
25. Test-drive the vehicle for several minutes in the range of the recorded freeze data.
26. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P2101 is indicated, check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then clean the throttle body, and go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - Troubleshooting is complete.