P2176
DTC P2176: Throttle Actuator Control System Idle Position Not LearnedNOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
- If DTC P2135 or P2552 is stored at the same time as DTC P2176, troubleshoot DTC P2135 or P2552 first, then recheck for DTC P2176.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Turn the ignition switch ON (II), and wait 10 seconds.
5. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P2176 indicated?
YES - Go to step 6.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then clean the throttle body.
6. Turn the ignition switch OFF.
7. Disconnect the intake air duct from the throttle body.
8. Turn the ignition switch ON (II).
9. Clear the DTC with the HDS.
10. Do the ETCS TEST in the INSPECTION MENU with the HDS.
11. Visually check the throttle valve operation.
NOTE: Be careful not to pinch your fingers. Keep your hands away from the throttle valve.
Does the throttle valve move to its fully closed position?
YES - Go to step 12.
NO - Go to step 13.
12. Check for sludge or carbon on the throttle valve.
Is there sludge or carbon on the throttle valve?
YES - Clean the throttle body, then go to step 23 and recheck.
NO - Go to step 20.
13. Turn the ignition switch OFF.
14. Disconnect the throttle body 6P connector.
15. Disconnect the C251 connector (13P) between the PCM subharness and the throttle actuator control module subharness.
16. Connect throttle body 6P connector terminals No. 5 and No. 6 with a jumper wire.
17. Check for continuity between C251 connector (13P) terminals No. 6 and No. 13.
Is there continuity?
YES - Go to step 18.
NO - Repair open in the wires between the throttle body and the C251 connector (motor drive lines), then go to step 22.
18. Disconnect the throttle actuator control module 16P connector.
19. Check for continuity between throttle actuator control module 16P connector terminals No. 1 and No. 8 and C251 connector (13P) terminals No. 6 and No. 13 individually.
Is there continuity?
YES - Substitute a known-good throttle actuator control module, then go to step 22 and recheck. If DTC P2176 is not indicated, replace the original throttle actuator control module, then go to step 22.
NO - Repair open in the wires between the throttle actuator control module and the C251 connector (motor drive lines), then go to step 22.
20. Turn the ignition switch OFF.
21. Replace the throttle body.
22. Reconnect all connectors.
23. Turn the ignition switch ON (II).
24. Reset the PCM with the HDS,
25. Do the PCM idle learn procedure.
26. Turn the ignition switch OFF.
27. Turn the ignition switch ON (II), and wait 10 seconds.
28. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P2176 is indicated, check for poor connections or loose terminals at the throttle body and the throttle actuator control module, then clean the throttle body, and go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - Troubleshooting is complete.