Trim Removal/Installation - Trunk Lid
Trim Removal/Installation - Trunk LidSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
1. Remove the trunk light.
2. Pull up on the outside ends of the trunk lid cushions (A), slide them to the outside and pull them out.
3. Detach all the clips, then remove the trunk lid trim (A).
4. If necessary, pivot the trunk lid handle (A) down on the forward hooks (B) while prying the rear hook (C), then remove the handle.
5. Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.