Carpet: Service and Repair

Carpet Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to damage, wrinkle or twist the carpet.
- Be careful not to damage the dashboard or other interior trim pieces.

1. Remove these items:
- Front seats, both sides
- Rear seat cushion
- Front door sill trim, both sides
- Rear door sill trim, both sides
- B-pillar lower trim, both sides
- Kick panel, both sides
- Center console
- Select lever bracket




2. Detach the clips, then remove the footrest (A).




3. Push the knob (A) back to release the hooks (B) then pull up the accelerator pedal (C).




4. Remove the bolts, then remove the rear vent duct C (A).




5. Detach the clips on both sides of the carpet (A). Pull the fastener (B) out, and pull out the carpet from under the plate (C), then remove the carpet.
6. Install the carpet in the reverse order of removal, and note these items:
- Take care not to damage, wrinkle or twist the carpet.
- Make sure the seat harnesses and antenna lead are routed correctly.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.