Center Console Armrest

Center Console Armrest Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Take care not to scratch the console.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Remove the center console.




2. Detach the clips, then remove the console trim (A). Disconnect the LF antenna connector (B).




3. Remove the screws (A) and detach the clips (B) and hooks (C), then remove the left console side trim (D) and right console side trim (E).




4. Remove the screws, and release the tabs (A), then remove the console outlet trim (B).




5. Remove the screws, hinge bushings (A), and hinge stoppers (B) from both sides, then remove the console armrest (C).
6. Remove the hinge springs (D) and bushings (E) from both sides.
7. Install the armrest in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.