Instrument Fascia

Instrument Fascia Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the dashboard and panels.

1. Tilt the steering column down, and telescope it out.
2. Remove the instrument fascia (A).
1. Gently pull out the bottom to release the clips (B,C).




2. Disconnect the illumination switch connector (D) and CMS OFF/VSA OFF/AFS OFF switch connector (E).

3. Install the instrument fascia in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips into place securely.