Power Seat Control Unit Input Test

Power Seat Control Unit Input Test

NOTE: Before troubleshooting the DPMS, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test mode A.

1. Turn the ignition switch OFF.
2. Remove the driver's seat.

NOTE: Be careful not to scratch the interior trim.




3. Disconnect the 40P connector (A) and 18P connector (B) from the power seat control unit (C).
4. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
- If the terminals look OK, go to step 5.




5. With the connectors still disconnected, make the input test at the connectors.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 6.




6. Reconnect the connectors to the power seat control unit, and make these input tests at the connectors.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace it.