Front Seat Cushion Cover
Front Seat Cushion Cover ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to tear the seams or damage the seat covers.
- Put on gloves to protect your hands.
1. Remove the front seat.
2. From under the seat cushion, detach the recline motor connector clip, the side airbag connector clip and the seat heater connector clip. Release the seat cushion cover from the seat cushion frame spring, then pull the cover back, and remove the clamps.
3. Remove the seat-back.
4. Release the hook strips (A) from both sides of the seat cushion.
5. Release the clips (A) and hooks (B), and disconnect the seat cushion heater connectors (C), then detach the connectors and harness clip (D), and pull back the seat cushion trim cover (E).
6. Remove the silencer (A) and seat cushion pad (B) from the seat cushion frame (C).
7. Pull back the seat cushion cover (A), and release the clips (B) from under the seat cushion.
8. Pull back the edge of the seat cushion cover all the way around, and release the clips (A), then remove the seat cushion cover.
9. Install the cover in the reverse order of removal, and note these items:
- To prevent wrinkles when installing a seat cushion cover, make sure the material is stretched evenly over the pad before securing the clips and hook strips.
- Replace any clips you removed with new ones (A). Install them with commercially available upholstery ring pliers (B).