With Manufacturer's Scan Tool

How to Check for DTCs (with the HDS)

1. Make sure the ignition switch is OFF.




2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
3. Turn the ignition switch ON (II).
4. Select DTCs in the BODY ELECTRICAL/CLIMATE CONTROL MODE menu of the HDS.
5. Check for DTCs. If any DTCs are indicated, go to the indicated DTCs troubleshooting. If no DTCs are indicated, refer to symptom troubleshooting.

NOTE: After troubleshooting, clear the DTCs with the HDS.