Transmission Range Switch Test
Transmission Range Switch Test1. Get the customer's radio and navigation anti-theft codes, and write down the radio presets.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the battery base.
7. Disconnect the transmission range switch connector.
8. Check for continuity between the terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.
Transmission Range Switch Connector:
9. The transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that transmission range switch installation. If the switch installation is OK, replace the switch.