Operation CHARM: Car repair manuals for everyone.

P0967

DTC P0967: Problem in A/T Clutch Pressure Control Solenoid Valve B

2005-2006 Models

NOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Clear the DTC with the HDS.
2. Check that DTC P0967 recurs.
Is DTC P0967 indicated?
YES - Go to step 6.
NO - Go to step 3.

3. Choose Clutch Pressure Control Solenoid Control in Miscellaneous Test Menu, and test the A/T clutch pressure control solenoid valve B with the HDS.
4. Drive with the A/T clutch pressure control solenoid valve B at 0.2 A in Clutch Pressure Control Solenoid Control menu.
5. Monitor the OBD status for P0967 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a failed?
YES - Go to step 6.
NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/T clutch pressure control solenoid valve B and PCM. If the tester indicates NOT COMPLETED, return to step 3 and recheck.

6. Turn the ignition switch OFF.
7. Disconnect the A/T clutch pressure control solenoid valve B connector.
8. Measure A/T clutch pressure control solenoid valve B resistance at the solenoid connector.





Is there 3 - 10 ohms?
YES - Go to step 9.
NO - Replace the A/T clutch pressure control solenoid valve B, then go to step 10.

9. Check for continuity between A/T clutch pressure control solenoid valve B connector terminal No. 2 and body ground.





Is there continuity?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
NO - Repair open in the wire between the A/T clutch pressure control solenoid valve B and ground (G101), or repair poor ground (G101), then go to step 10.

10. Clear the DTC with the HDS.
11. Test-drive the vehicle for several minutes in the D position through all five gears.
12. Monitor the OBD status for P0967 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a passed?
YES - Troubleshooting is completed.
NO - Return to step 1 and recheck.