P0982
DTC P0982: Short in Shift Solenoid Valve D Circuit2005-2006 Models
NOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
1. Clear the DTC with the HDS.
2. Start the engine, and shift the transmission in 2nd gear in the M position.
3. Check that DTC P0982 recurs.
Is DTC P0982 indicated?
YES - Go to step 7.
NO - Go to step 4.
4. Choose Shift Solenoid D in Miscellaneous Test Menu, and test the shift solenoid valve D with the HDS.
5. Start the engine, and shift the transmission in 2nd gear in the M position.
6. Monitor the OBD status for P0982 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a failed?
YES - Go to step 7.
NO - Intermittent failure, the system is OK at this time. Check the GRN/RED wire for an intermittent short to ground between shift solenoid valve D and PCM. If the tester indicates NOT COMPLETED, return to step 4 and recheck.
7. Turn the ignition switch OFF.
8. Jump the SCS line with the HDS.
9. Disconnect PCM connectors A (31P) and C (22P).
10. Measure the resistance between PCM connector terminals C5 and A9.
Is there less than 12 ohms?
YES - Go to step 11.
NO - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
11. Disconnect the shift solenoid harness connector at the transmission housing.
12. Check for continuity between PCM connector terminals C5 and A9.
Is there continuity?
YES - Repair short to ground in the wire between PCM connector terminal C5 and the shift solenoid harness connector, then go to step 13.
NO - Check shift solenoid valve D, and check for a short in the shift solenoid harness in the transmission. Replace shift solenoid valve D and/or shift solenoid harness, then go step 13.
13. Clear the DTC with the HDS.
14. Start the engine, and shift the transmission in 2nd gear in the M position.
15. Monitor the OBD status for P0982 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a passed?
YES - Troubleshooting is completed.
NO - Return to step 7 and recheck.