Carpet: Service and Repair

Carpet Replacement

Special Tools Required
KTC trim tool set SOJATP20U

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to damage, wrinkle, or twist the carpet.
- Be careful not to damage the dashboard or other interior trim pieces.

1. Remove these items:
- Front seats, both sides
- Rear seat cushion
- Center console
- Door sill trim, both sides
- Kick panel, both sides
- Door opening trim, both sides
- Front seat belt lower anchor, both sides




2. Detach the clips, then remove the footrest (A)




3. Using a utility knife, cut the carpet (A) at the shift lever area (B) and parking brake lever area (C) as shown.




4. Remove the carpet (A).
1. Remove the clip.
2. Release the fasteners (B), then pull back the carpet from under the dashboard.
3. Remove the front lower portions of both rear side trim panels (C) as necessary.
4. Pull the carpet out from both rear side trim panels.
5. If necessary, remove the floor mat holders (D).

5. Install the carpet in the reverse order of removal, and note these items:
- Take care not to damage, wrinkle, or twist the carpet.
- Make sure the seat harnesses are rooted correctly.
- Slip the carpet under the rear side trim panel on each side property.
- Replace the clip Hit's damaged.
- Reattach the cut teas at the shift lever and parking brake lever with wire ties.
- When installing new carpet, cut the carpet at the shift lever and parking brake lever. After installing the new carpet, reattach the cut areas with wire ties.