Rear Crankshaft Main Bearing Seal: Service and Repair
Transmission End Crankshaft Oil Seal Installation - In CarSpecial Tools Required
^ Driver 07749-0010000
^ Oil seal driver attachment 96 07ZAD-PNAA100
1. A/T model: Remove the transmission, then remove the drive plate.
2. M/T model: Remove the transmission. Remove the pressure plate and clutch disc, then remove the flywheel.
3. Dry the crankshaft oil seal housing.
4. Use the special tools to drive a new oil seal squarely into the block to the specified installed height.
5. Measure the distance between the crankshaft (A) and oil seal (B).
6. A/T model: Install the drive plate, then install the transmission.
7. M/T model: Install the flywheel, then install the clutch disc and pressure plate. Install the transmission.