A/C Condenser Fan Circuit Troubleshooting
A/C Condenser Fan Circuit TroubleshootingNOTE:
- Do not use this troubleshooting procedure if the radiator fan and/or the A/C compressor is inoperative. Refer to the symptom troubleshooting index. Symptom Related Diagnostic Procedures
- Before performing symptom troubleshooting, check for powertrain DTCs.
1. Check the No.1 (30 A) fuse in the under-hood fuse/relay box, and the No.14 (10 A) fuse in the under-dash fuse/relay box.
Are the fuses OK?
YES - Go to step 2.
NO - Replace the fuse(s), and recheck.
2. Remove the A/C condenser fan relay from the under-hood fuse/relay box, and test it.
Is the relay OK?
YES - Go to step 3.
NO - Replace the A/C condenser fan relay.
3. Measure the voltage between the No.2 terminal of the A/C condenser fan relay 4P socket and body ground.
Is there battery voltage?
YES - Go to step 4.
NO - Replace the under-hood fuse/relay box.
4. Connect the No.1 and No.2 terminals of the A/C condenser fan relay 4P socket with a jumper wire.
Does the A/C condenser fan run?
YES - Go to step 5.
NO - Go to step 8.
5. Disconnect the jumper wire.
6. Turn the ignition switch ON (II).
7. Measure the voltage between the No.3 terminal of the A/C condenser fan relay 4P socket and body ground.
Is there battery voltage?
YES - Replace the under-hood fuse/relay box.
NO - Repair open in the BLK/YEL wire between the No.14 (10 A) fuse in the under-dash fuse/relay box and the A/C condenser fan relay.
8. Disconnect the jumper wire.
9. Disconnect the A/C condenser fan 2P connector.
10. Check for continuity between the No.1 terminal of the A/C condenser fan relay 4P socket and the No.2 terminal of the A/C condenser fan 2P connector.
Is there continuity?
YES - Go to step 11.
NO - Repair open in the wire between the A/C condenser fan relay and the A/C condenser fan.
11. Check for continuity between the No.1 terminal of the A/C condenser fan 2P connector and body ground.
Is there continuity?
YES - Replace the A/C condenser fan motor.
NO - Check for an open in the wire between the A/C condenser fan and body ground. If the wire is OK, check for poor ground at G302.