Suspension - Front Suspension Clunking On Turns
06-026August 15, 2006
Applies To:
2005-06 RSX - ALL
Clunking Noise While Turning
SYMPTOM
The front suspension makes a clunking noise while turning.
PROBABLE CAUSE
The front springs are moving on the spring seats.
CORRECTIVE ACTION
Replace both front springs, and do a four-wheel alignment.
PARTS INFORMATION
RSX Type S
Right-Front Spring: P/N 51401-S6M-A52
Left-Front Spring: P/N 51406-S6M-A52
RSX (M/T)
Right-Front Spring: P/N 51401-S6M-C02
Left-Front Spring: P/N 51406-S6M-C02
RSX (A/T)
Right-Front Spring: P/N 51401-S6M-J02
Left-Front Spring: P/N 51406-S6M-J02
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Operation Number: 414101
Flat Rate Time: 2.1 hours
Failed Part: P/N 51401-56M-306
Defect Code: 07403
Symptom Code: 04201
Template ID: 06-026A (RSX Type S)
06-026B (RSX M/T)
06-026C (RSX A/T)
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
DIAGNOSIS
With the engine running, while either parked or driving at 5 mph, turn the steering wheel from lock to lock and listen for a clunk.
^ If you hear a clunk, go to REPAIR PROCEDURE.
^ If you do not hear a clunk, continue with troubleshooting. This bulletin does not apply.
REPAIR PROCEDURE
1. Replace the front springs.
NOTE:
Be sure the wrapped or insulated end of the spring is installed against the spring seat.
^ Refer to page 18-20 of the 02-06 HSX Service Manual, or
^ Online, enter the keyword SUSPENSION, then select Front Damper/Spring Replacement from the list.
2. Do a four-wheel alignment.
3. Test-drive the vehicle to make sure the noise is gone.
Disclaimer