ECM/PCM Updating and Substitution For Testing

ECM/PCM Updating and Substitution for Testing

Special Tools Required
Honda interface module (HIM) EQS05A35570

Use this procedure when you have to substitute a known-good ECM/PCM in a troubleshooting procedure. Update the ECM/PCM only if the ECM/PCM does not have the latest software loaded.

NOTE: Do not turn the ignition switch OFF white updating the ECM/PCM. If you turn the ignition switch OFF before completion, the ECM/PCM can be damaged.

How to Update the ECM/PCM

NOTE:
- To ensure the latest program is installed, do an ECM/PCM update whenever the ECM/PCM is substituted or replaced.
- You can not update an ECM/PCM with the program it already has. It will only accept a new program.
- Before you update the ECM/PCM, make sure the vehicle's battery is fully charged.
- To prevent ECM/PCM damage, do not operate anything electrical (audio system, brakes, A/C, power windows, moonroof, door locks, etc.) during the update.
- If you need to diagnose the Honda interface module (HIM) because the HIM's red (#3) light came on or was flashing during the update, leave the ignition switch in the ON (II) position when you disconnect the HIM from the data link connector (DLC). This will prevent ECM/PCM damage.

1. Turn the ignition switch ON (II). Do not start the engine.




2. Connect the HDS or the Honda interface module (HIM) to the data link connector (DLC) (A) located under the driver's side of the dashboard.
3. Do the ECM/PCM update procedure as described on the HIM label or in the ECM/PCM update system.
4. Do the ECM/PCM idle learn procedure, 2002-2004 models, 2005-2006 models.
5. 2005-2006 models: Clear the CKP pattern with the HDS while the engine is stopped.

How to Substitute the ECM/PCM (2005-2006 Models)




1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Jump the SCS line with the HDS.




3. Remove the passenger's dashboard lower cover (A).
4. Disconnect the ECM/PCM connectors (B).
5. Remove the ECM/PCM mounting bolts (C) and the ECM/PCM (D).
6. Install the ECM/PCM in the reverse order of removal.
7. Open the SCS with the HDS.
8. Turn the ignition switch ON (II).

NOTE: DTC: P0630 "VIN Not Programmed or Mismatch" may be stored because the VIN has not been programmed into the ECM/PCM; ignore it, and continue this procedure.

9. Input the VIN to the ECM/PCM with the HDS.
10. Rewrite the immobilizer code with the ECM/PCM replacement procedure in the HDS; it allows you to start the engine.
11. Reset the ECM/PCM with the HDS.
12. Do the ECM/PCM idle learn procedure.
13. Do the CKP pattern learn procedure.