CKP Sensor Replacement

CKP Sensor Replacement

1. Disconnect the CKP sensor 3P connector.




2. Remove the CKP sensor (A).
3. Install the sensor in the reverse order of removal with a new O-ring (B).
4. Do the CKP pattern clear/pattern learn procedure below.

CKP Pattern Clear/CKP Pattern Learn (2005-2006 Models)

NOTE: The ECT needs to be at 176 degree F (80 degree C) or higher.

1. Clear the CKP PATTERN CLEAR with the HDS while the engine is stopped.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON (II), and wait 30 seconds.
4. Test-drive the vehicle on a level road: decelerate (with the throttle fully closed) from an engine speed of 2,500 rpm to 1,000 rpm with the A/T 2nd gear in M position, or the M/T in 2nd or 3rd gear.
5. Stop the vehicle. Do not turn the ignition off.
6. Select the ALL DATA LIST in the DATA LIST MENU of the HDS.
7. Check the status of PULSER F/B LEARN. If it is set to NG, the enable criteria was probably not met; repeat the procedure from the beginning.