Front Impact Sensor
Front Impact Sensor ReplacementRemoval
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the front inner fender.
3. Disconnect the engine compartment wire harness 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front impact sensor (C).
Installation
1. Install the new front impact sensor with new Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor(C).
2. Reinstall the front inner fender.
3. Reconnect the battery negative cable.
4. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.