Power Window Control Module: Testing and Inspection

Resetting the Power Window Control Unit

Resetting the power window control unit is required after performing the following procedures:

- Disconnecting the battery
- Removing the No.6 (7.5 A) and/or the No.23 (20 A) fuses in the under-dash fuse/relay box
- Disconnecting the driver's door wire harness
- Disconnecting the power window control unit

1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down holding the driver's switch in the AUTO DOWN position; when the window reaches the bottom, hold the driver's window switch in the AUTO DOWN position for 2 seconds.
3. Move the driver's window all the way up holding the driver's switch in the AUTO UP position; when the window reaches the top, hold the driver's window switch in the UP position for 2 seconds.
4. If the window does not work in AUTO, repeat steps 1 through 3.