Front Carpet Replacement

Front Carpet Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to damage, wrinkle or twist the carpet.
- Be careful not to damage the dashboard or other interior trim pieces.

1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove these items:
- Front seats, both sides
- Front door sill trim, both sides
- Kick panel, both sides
- Center console rear section
- Center console panel
- Rear vent duct
- Fuel fill door opener cover
- Driver's dashboard under cover
- Passenger's dashboard under cover
- Steering joint cover




4. Push the knob (A) back to release the hook (B) then pull up the accelerator pedal (C).




5. Detach the clips, then remove the footrest (A).




6. Disconnect the antenna lead (A), the side curtain airbag subharness connector (B), and the parking brake switch (C). Detach the harness clips (D), and on A/T model, harness clips (E).




7. Remove the bolts securing the shift lever bracket or select lever bracket (A).




8. Release the clips (A, B) from the front floor carpet (C).
9. Release the hooks (D) with a flat-tip screwdriver by pushing the screwdriver toward the door, then lift upwards. Pull the fastener (E) out, then remove the carpet.
10. Install the carpet in the reverse order of removal, and note these items:
- Take care not to damage, wrinkle or twist the carpet.
- Make sure the seat harnesses and antenna lead are routed correctly.
- Check for damaged or stress-whitened clips, and replace them with new ones.
- Reconnect the negative cable to the battery.
- Set the clock.
- Enter the anti-theft codes for the radio and the navigation system, then enter the audio presets.