Center Console Rear Section

Center Console Rear Section Removal/Installation

Special Tools Required
KTC trim tool set SOJAT2O14 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the front seat, dashboard, and related pants.




1. M/T: Lower the shift lever boot (A) to release the hooks (B) from the boot, then remove the shift knob (C).




2. Detach the clips (A, B), and release the hooks (C) by carefully inserting a trim tool between the HVAC panel and the center console trim (D) and prying gently on both sides.




3. Open the console box lid (A) then remove the console mat (B) and screws (C, D).




4. Slide the rear section of the center console (A) rearward to release the hooks (B).




5. Lift up the rear of the console (A). Release the harness retainer clip (B) from the air duct, and disconnect the accessory power socket connector (C) and the light bulb socket connector (D) and then remove the rear section of the center console.
6. Install the console in the reverse order of removal, and replace any damaged clips.