A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement1. Make sure you have the anti-theft codes for the radio and navigation system, and write down the audio presets.
2. Remove the left side engine compartment cover.
3. Make sure the ignition switch is OFF. Disconnect the negative cable from the battery first, then disconnect the positive cable.
4. Remove the battery. hold-down bracket, then remove the battery and battery tray.
5. Remove the air intake duct and air cleaner housing.
6. Remove the transmission upper mount bracket (A) and bracket plate (B).
7. Remove the bolt securing the harness clamp bracket (C). Then remove the remaining bolts and A/T clutch pressure control solenoid valve A and B.
8. Remove A/T clutch pressure control solenoid valve A and B, O-rings (D), 8 x 8 mm ATF feed pipes (E), gasket (F), and 8 x 40 mm ATF feed pipe (G).
9. Place a new gasket on the transmission housing, then install the 8 x 18 mm ATF feed pipes with their filter side into the transmission housing.
10. Install new O-rings over the feed pipes, and install the 8 x 40 mm ATF feed pipe.
11. Install the new A/T clutch pressure control solenoid valve A and B, and harness clamp.
12. Check the A/T clutch pressure control solenoid valve A and B connectors for corrosion, dirt, and oil, then connect them securely.
13. Install the transmission upper mount bracket and bracket plate.
14. Install the air cleaner housing and air intake duct.
15. Install the battery tray, battery, and battery hold down bracket.
16. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
17. Install the left side engine compartment cover.
18. Enter the anti-theft codes for the radio and navigation system, then enter the audio presets, and set the clock.