Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2006 >> TL V6-3.2L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Actuators and Solenoids - Transmission and Drivetrain >> Actuators and Solenoids - A/T >> Pressure Regulating Solenoid >> Service and Repair >> A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Make sure you have the anti-theft codes for the radio and navigation system, and write down the audio presets.
2. Remove the left side engine compartment cover.
3. Make sure the ignition switch is OFF. Disconnect the battery negative terminal, then disconnect the battery positive terminal.
4. Remove the battery hold-down bracket, then remove the battery and battery tray.
5. Remove the air intake cover and air intake tube.
6. Remove the splash shield.
7. Remove the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base.
8. Disconnect the A/T clutch pressure control solenoid valve C connector.





9. Remove A/T clutch pressure control solenoid valve C.
10. Remove the gasket (A) and 8 x 12 mm ATF feed pipe (B).
11. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
12. Install the 8 x 12 mm ATF feed pipe with its filter side into the transmission housing.
13. Install the new gasket in the mounting groove of the A/T clutch pressure control solenoid valve C body properly, then install A/T clutch pressure control solenoid valve C on the transmission housing. Do not pinch the gasket.
14. Check the A/T clutch pressure control solenoid valve C connector for corrosion, dirt, and oil, then connect it securely.
15. Install the battery base, then install the air cleaner housing and air intake duct.
16. Install the air intake cover and air intake tube.
17. Install the splash shield.
18. Install the battery, tray, battery, and battery hold down bracket.
19. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
20. Install the left side engine compartment cover.
21. Enter the anti-theft codes for the radio and navigation system, then enter the audio presets, and set the clock.
pro multis · About Operation CHARM