Shift Solenoid Valve A Replacement
Shift Solenoid Valve A Replacement1. Make sure you have the anti-theft codes for the radio and navigation system, and write down the audio presets.
2. Remove the left side engine compartment cover.
3. Make sure the ignition switch is OFF. Disconnect the negative cable from the battery first, then disconnect the positive cable.
4. Remove the battery hold-down bracket, then remove the battery and battery tray.
5. Remove the air intake cover and air intake tube.
6. Remove the air intake duct and air cleaner housing.
7. Remove the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base.
8. Remove the starter.
9. Disconnect the shift solenoid valve A connector, and remove shift solenoid valve A.
10. Install a new shift solenoid valve A with new O-rings (B). While installing the solenoid valve, do not allow dust or other foreign particles to enter the transmission.
11. Check the connector for corrosion, dirt, and oil, then connect the connector.
12. Install the starter.
13. Install the battery base, then install the air cleaner housing and air intake duct.
14. Install the air intake cover and air intake tube.
15. Install the battery tray, battery, and battery hold down bracket.
16. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
17. Install the left side engine compartment cover.
18. Enter the anti-theft codes for the radio and navigation system, then enter the audio presets, and set the clock.