DTC 71-1x

DTC 71-1x (71-10 to 71-19,71-1A to 71-1F): Open in Driver's Seat Position Sensor ('06 model)

Special Tools Required
SRS inflator simulator 07SAZ-TB4011A

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 71-1x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Initial Inspection and Diagnostic OverviewIf another DTC is indicated, go to the DTC Troubleshooting Index. Diagnostic Trouble Code Descriptions

3. Check the connection between the seat position sensor harness 2P connector and the driver's seat position sensor.
4. Erase the DTC memory.
5. Read the DTC.

Is DTC 71-1x indicated?

YES - Go to step 6.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Initial Inspection and Diagnostic OverviewIf another DTC is indicated, go to the DTC Troubleshooting Index. Diagnostic Trouble Code Descriptions

6. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




7. Disconnect the driver's seat wire harness 2P connector from the driver's seat position sensor (A).
8. Connect the No. 1 and No. 2 terminals of the driver's seat wire harness 2P connector with a jumper wire.
9. Disconnect both seat belt tensioner 4P connectors.
10. Disconnect SRS unit connector B (28P) from the SRS unit.




11. Check resistance between the No. 16 and No. 28 terminals of SRS unit connector B (28P). There should be 0 - 1.0 Ohm.

Is the resistance as specified?

YES - Faulty driver's seat position sensor or SRS unit; replace the driver's seat position sensor. If the problem is still present, replace the SRS unit.

NO - Open in the floor wire harness or seat position sensor harness; replace the faulty harness.