DTC 53

DTC 53: Motor Stuck ON
1. Turn the ignition switch ON (II).
2. Measure the voltage between the VSA modulator control unit 47P connector terminal No. 47 and body ground.





Is there less than 0.1 V?
YES - Go to step 3.
NO - Repair open in the wire between the VSA modulator-control unit and body ground (G203).

3. Clear the DTC using the HDS.
4. Disconnect the HDS from the 16P DLC.
5. Turn the ignition switch OFF, then turn it ON (II) again.
6. Test-drive the vehicle.
Does the ABS indicator come on, and is DTC 53 indicated?
YES - Replace the VSA modulator-control unit.
NO - The system is OK at this time. Refer to intermittent failures.