DTC 84

DTC 84: VSA Sensor Neutral Position
1. Clear the DTC using the HDS.
2. Disconnect the HDS from the 16P DLC.
3. Turn the ignition switch OFF, then turn it ON (II) again.
4. Test-drive the vehicle.
Does the VSA indicator come on, and is DTC 84 indicated?
YES - Go to step 5.
NO - The system is OK at this time. Refer to intermittent failures.

5. Do the VSA sensor neutral position memorization. Programming and Relearning
6. Clear the DTC using the HDS.
7. Disconnect the HDS from the 16P DLC.
8. Turn the ignition switch OFF, then turn it ON (II) again.
9. Test-drive the vehicle.
Does the VSA indicator come on, and is DTC 84 indicated?
YES - Check for loose terminals in the VSA modulator-control unit 47P connector. If no loose terminals are found, replace the VSA modulator control unit.
NO - The system is OK at this time. Refer to intermittent failures.