P1730

DTC P1730: Problem in Shift Control System:
^ Shift Solenoid Valves A or D Stuck OFF
^ Shift Solenoid Valve B Stuck ON
^ Shift Valves A, B, or D Stuck

NOTE: Record all freeze data and review General Troubleshooting Information before you troubleshoot.

1. Warm up the engine to normal operating temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.
3. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.
Does the strainer contain metal debris or excessive clutch material?
YES - Replace the transmission.
NO - Replace the ATF, then go to step 4.

4. Clear the DTC with the HDS.
5. Test-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
6. Test-drive the vehicle again in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
7. Monitor the OBD status for P1730 with the DTC Monitor Tool in DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate FAILED?
YES - Go to step 8.
NO - If the tester indicates PASSED, intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETED, return to step 5 and recheck.

8. Clear the DTC with the HDS.
9. Select Shift Solenoid A in Miscellaneous Test Menu, and check that shift solenoid valve A operates with the HDS.
Is a clicking sound heard?
YES - Go to step 10.
NO - Replace shift solenoid valve A, then go to step 15.

10. Select Shift Solenoid B in Miscellaneous Test Menu, and check that shift solenoid valve B operates with the HDS.
Is a clicking sound heard?
YES - Go to step 11.
NO - Replace shift solenoid valve B, then go to step 15.

11. Select Shift Solenoid D in Miscellaneous Test Menu, and check that shift solenoid valve D operates with the HDS.
Is a clicking sound heard?
YES - Go to step 12.
NO - Replace shift solenoid valve D, then go to step 15.

12. Test-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
13. Test-drive the vehicle again in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
14. Monitor the OBD status for P1730 with the DTC Monitor Tool in DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate FAILED?
YES - Repair hydraulic system related with shift valves A, B, and D, or replace the transmission, then go to step 15.
NO - Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETED, return to step 12 and recheck.

15. Clear the DTC with the HDS.
16. Test-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
17. Test-drive the vehicle again in the D position through all five gears at speeds over 12 mph (20 km/h) for more than 20 seconds, then slow down to a stop.
18. Monitor the OBD status for P1730 with the DTC Monitor Tool in DTCs/Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate PASSED?
YES - Troubleshooting is complete.
NO - Return to step 8 and recheck.