Control Arm Replacement

Control Arm Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the rear wheel.





3. Remove the control arm mounting nut (A) and washer (B) from the knuckle side.
4. Mark the cam positions of the adjusting bolt (C) and adjusting cam (D), then remove the self-locking nut (E), and adjusting cam, and adjusting bolt. Discard the self-locking nut and control arm mounting nut.
5. Remove the control arm (F).
6. Install the control arm in the reverse order of removal, and note these items:
^ Align the cam positions of the adjusting bolt and adjusting cam with the marked positions when tightening.
^ Tighten all mounting hardware to the specified torque values.
^ Use a new self-locking nut, new adjusting bolt, and new mounting nut on reassembly.
^ First install all the components and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully tightening to the specified torque values.
^ Before installing the wheel, clean the mating surface on the brake disc and inside of the wheel.
^ Check the wheel alignment, and adjust it if necessary.