B1842

DTC B1842: Power Tilt/Telescopic Position Sensor Power Supply Circuit (SVCC Line) Short

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Operate the tilt/telescopic switch in each direction for more than 1 second.
4. Check for DTCs with the HDS.

Is DTC B1842 indicated?

YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections at the tilt motor/position sensor connector, at the telescopic motor/position sensor connector, and at the power tilt/telescopic control unit connector.

5. Turn the ignition switch OFF.
6. Disconnect power tilt/telescopic control unit connector A (16P).
7. Disconnect the telescopic motor/position sensor 8P connector.
8. Disconnect the tilt motor/position sensor 6P connector.




9. Check for continuity between power tilt/telescopic control unit connector A (16P) terminal No. 2 and body ground.

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 10.




10. At the sensor side, check for continuity between telescopic motor/position sensor 8P connector terminal No. 5 and body ground (motor body).

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 11.




11. At the sensor side, check for continuity between tilt motor/position sensor 6P connector terminal No. 3 and body ground (motor body).

Is there continuity?

YES - Replace the tilt motor/position sensor.

NO - Replace the power tilt/telescopic control unit.