DTC 32-11

DTC 32-11: Open in Front Passenger's Side Airbag Inflator

DTC 32-21: Increased Resistance in Front Passenger's Side Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 32-11 or 32-21 indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, go to the DTC Troubleshooting Index. Diagnostic Trouble Code Descriptions

3. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.




4. Disconnect the right side wire harness 2P connector (A) from the front passenger's side airbag (B).
5. Connect the SRS inflator simulator (2 ohms connectors) and simulator lead E to the right side wire harness.
6. Reconnect the negative cable to the battery.
7. Erase the DTC memory.
8. Read the DTC.

Is DTC 32-11 or 32-21 indicated?

YES - Go to step 9.

NO - Open or increased resistance in the front passenger's side airbag inflator; replace the front passenger's side airbag.

9. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.
10. Disconnect SRS unit connector C (28P) from the SRS unit.
11. Disconnect the SRS inflator simulator from the SRS simulator lead.




12. Check resistance between the terminals of the SRS simulator lead. There should be 1.0 ohm or less.

Is the resistance as specified?

YES - Faulty SRS unit or poor connection at SRS unit connector C (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.

NO - Open or increased resistance in the right side wire harness; replace the right side wire harness.