DTC A2-11

DTC A2-11: Faulty power supply (VB line)

1. Check the No. 22 (10 A) fuse in the driver's under-dash fuse/relay box.

Is the fuse OK?

YES - Go to step 11.

NO - Go to step 2.

2. Replace the No. 22 (10 A) fuse.
3. Turn the ignition switch ON (II), and wait for 30 seconds. Then turn the ignition switch OFF.
4. Check the No. 22 (10 A) fuse.

Is the fuse OK?

YES - The system is OK at this time.

NO - Go to step 5.

5. Replace the No. 22 (10 A) fuse.
6. Turn the ignition switch OFF. Disconnect the negative cable from the battery.
7. Disconnect SRS unit connector A (28P) from the SRS unit.
8. Reconnect the negative cable to the battery.
9. Turn the ignition switch ON (II) and wait for 30 seconds. Then turn the ignition switch OFF.

10. Check the No. 22 (10 A) fuse.

Is the fuse OK?

YES - Short to ground in the SRS unit; replace the SRS unit.

NO - Short to ground in dashboard wire harness A or in the driver's under-dash fuse/relay box No. 22 (10 A) fuse circuit; replace dashboard wire harness A. If the problem is still present, replace the driver's under-dash fuse/relay box.

11. Turn the ignition switch OFF. Disconnect the negative cable from the battery.
12. Disconnect SRS unit connector A (28P) from the SRS unit.
13. Reconnect the negative cable to the battery.




14. Connect a voltmeter between the No. 18 terminal of SRS unit connector A (28P) and body ground. Turn the ignition switch ON (II), and measure the voltage. There should be battery voltage.

Is there battery voltage?

YES - Faulty SRS unit or poor contact at SRS unit connector A (28P) and the SRS unit; check the connection. If the connection is OK, replace the SRS unit.

NO - Go to step 15.

15. Turn the ignition switch OFF.




16. Disconnect under-dash fuse/relay box connector S (2P).




17. Check resistance between the No. 2 terminal of driver's under-dash fuse/relay box connector S (2P) and the No. 18 terminal of SRS unit connector A (28P). There should be 0 - 1.0 ohm.

Is the resistance as specified?

YES - Open in the driver's under-dash fuse/relay box or poor connection between connector S (2P) and the driver's under-dash fuse/relay box; check the connection. If the connection is OK, replace the driver's under-dash fuse/relay box.

NO - Open in dashboard wire harness A; replace dashboard wire harness A.