DTC 65

DTC 65: Brake Fluid Level

1. Check the brake fluid level.

Is the level correct?

YES-Go to step 2.

NO-Inspect the brake system for fluid leaks. If no (leaks are found, replace all worn brake pads.

2. Disconnect gauge control module connector B (28P) and brake fluid level switch 2P connector.
3. Check for continuity between terminal No. 13 of gauge control module connector B (28P) and body ground.





Is there continuity?

YES-Repair short to body ground in the wire between gauge control module connector B and the brake fluid level switch.

NO-Go to step 4.

4. Check the brake fluid level switch. Is the switch OK?

YES-Do the troubleshooting for the gauge control module.

NO-Replace the brake fluid level switch.