DTC 35-1

DTC 35-1, 35-2: Yaw Rate Sensor Neutral Position

1. Clear the DTC with the HDS.
2. Start the engine.
3. Check for DTCs with the HDS.

Is DTC 35-1 and/or 35-2 indicated?

YES - Go to step 4.

NO - Intermittent failure, the system is OK at this time.

4. Place the vehicle on a flat surface.
5. Check the lateral/longitudinal acceleration sensor A/D value in the DATA LIST with the HDS.

Is there 2.2 - 2.8 V?

YES - Go to step 6.

NO - Check the yaw rate-lateral/longitudinal acceleration sensor installation.

6. Do the yaw rate-lateral/longitudinal acceleration neutral position memorization. Neutral Position Memorization

Is the value "OK"?

YES - Troubleshooting is complete; the vehicle is repaired.

NO - Replace the yaw rate sensor.