DTC 61-1

DTC 61-1: Shift Solenoid Valve (Open)

1. Clear the DTC with the HDS.
2. Do the shift solenoid valve function test with the HDS.
3. Check for DTCs with the HDS.

Is DTC 61-1 indicated?

YES - Go to step 4.

NO - Intermittent failure, the system is OK at this time.

4. Turn the ignition switch OFF.
5. Disconnect SH-AWD control unit connectors A (26P) and B (8P).
6. Check for continuity between SH-AWD control unit connector terminals A1 and B8.





Is there 15-20 Ohms?

YES - Check for loose connector terminals at the SH-AWD control unit, and repair if necessary. If the connections are OK, substitute a known-good SH-AWD control unit and recheck.

NO - Go to step 7.

7. Connect a jumper wire between SH-AWD control unit connector terminals A1 and B8. Disconnect the shift solenoid valve 2P connector, then check for continuity between shift solenoid valve 2P connector terminals No. 1 and No. 2.








Is there continuity?

YES - Replace the shift solenoid valve.

NO - Repair open in the wire between the SH-AWD control unit and the shift solenoid valve.