Advanced Diagnostics

DTC P0339: Crankshaft Position (CKP) Sensor A Intermittent Interruption




General Description
Crankshaft position (CKP) sensor A consists of a rotor and a semiconductor that detects rotor position. When the engine starts, the rotor turns and the magnetic flux in the semiconductor changes. The changes of magnetic flux are converted into pulsing signals to the powertrain control module (PCM). CKP sensor A detects injection/ignition timing for each cylinder and engine speed.

If an abnormal amount of pulsing signals are detected from CKP sensor A, a malfunction is detected and a DTC is stored.




Monitor Execution, Sequence, Duration, DTC Type, OBD Status




Enable Conditions

Malfunction Threshold
Other than 22 pulses are detected during intervals between reference pulses for each crankshaft revolution. This condition has been detected at least 30 times.

Diagnosis Details

Conditions for illuminating the MIL
When a malfunction is detected, the MIL comes on and the DTC and the freeze frame data are stored in the PCM memory.

Conditions for clearing the MIL
The MIL will be cleared if the malfunction does not recur during three consecutive trips in which the diagnostic runs.

The MIL, the DTC, and the freeze frame data can be cleared by using the scan tool Clear command or by disconnecting the battery.