Rear Bumper: Service and Repair

Rear Bumper Removal/Installation

Special Tools Required
- KTC trim tool set SOJATP2014 *
- Push pin puller 07AAC-SJAA100
* Available through the American Honda Tool and Equipment Program

NOTE:
- Have an assistant help you when removing and installing the rear bumper.
- Take care not to scratch the rear bumper and body.
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.




1. Remove the bolts (A), screws (B), and clips (C, D) securing the rear bumper (E).




2. Pull on the rear bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacers (C).




3. With the help of an assistant, pull the wheel arch portion away from the side spacer (A), while pulling the rear bumper (B) to release the bumper from the hooks C) on the side bracket (D).




4. With the help of an assistant, pull the rear bumper (A) to release the bumper from the hooks (B) on both upper brackets (C).




5. Release the hooks, then remove the rear bumper absorber (A).
6. Install the bumper in the reverse order of removal, and note these items:
- Make sure the rear bumper engages the hooks (of both upper bracket, side bracket, and side spacers) on each side securely.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and hooks into place securely.