Under-Hood Fuse/Relay Box

Removal and Installation

Removal

1. Make sure you have the anti-theft codes for the audio and the navigation system. If equipped with XM radio, write down the XM radio presets. Make sure the ignition switch is OFF.
2. Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.




3. Remove the screws (A) for the alternator and battery cable terminals from the under-hood fuse/relay box.
4. Remove the two mounting bolts (B) from the under-hood fuse/relay box.
5. Remove the bottom cover from the under-hood fuse/relay box.
6. Disconnect the connectors from the under-hood fuse/relay box.
7. Carefully remove the relays by prying under the base of the relay.

NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.

Installation

1. Install the relays and connect the connectors to the under-hood fuse/relay box, then install the under hood fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Connect the positive cable to the battery, then connect the negative cable to battery.
4. Enter the audio and navigation system anti-theft codes, and set the clock. If the XM radio is equipped, enter the XM radio presets.
5. Confirm that all systems work properly.