B1706

DTC B1706: Display Panel Control Unit Lost Communication with the Gauge Control Module (VSP/NE Signal)

NOTE:
- Display panel control unit DTCs may not clear using the HDS. If the DTCs will not clear, manually reset the display panel control unit.
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A.

1. Clear for DTC with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Check for DTCs with the HDS.

Is DTC B1706 indicated?

YES - Go to step 4.

NO - Intermittent failure. The display panel control unit is OK at this time. Check loose and poor connections.

4. Check for DTCs with the HDS.

Are any of the following DTCs indicated: B1011, B1060, or B1805?

YES - Go to the Gauge Control Module Input Test. Gauge Control Module Input Test

NO - Replace the display panel control unit.