Programming and Relearning

Moonroof Calibration

NOTE: The moonroof calibration must be performed when any of the following events have occurred.
- The moonroof is manually moved with the battery dead or disconnected.
- The moonroof motor is replaced with a new one.
- Any component related to the moonroof replaced.
- Wind deflector
- Moonroof glass
- Moonroof seal
- Moonroof glass bracket
- Moonroof cables, etc.

To calibrate the moonroof, perform the following steps
1. Turn the ignition switch ON (II).
2. Open the moonroof to full open position and release the open button.
3. Pull and hold the moonroof OPEN switch until the moonroof glass moves slightly back to its mechanical stop and then forward again slightly.
- New Motor
- Other than new motor: This will take about 13 seconds.

4. Release the OPEN switch.
5. Within 5 seconds, pull and hold the moonroof OPEN switch again.
6. In about 3 seconds the moonroof glass will begin to slide closed.
7. Continue to hold the open button until the glass moves to closed position, tilts up, and returns to the closed position again.
8. Test the moonroof auto operation.