Torque Specifications

Cylinder head





If either diameter is less than 11.3 mm (0.44 in.), replace the cylinder head bolt.

Torque the cylinder head bolts in sequence to 30 Nm (3.0 kgf-m, 22 lbf-ft). Use a beam-type torque wrench. When using a preset-type torque wrench, be sure to tighten slowly and do not overtighten. If a bolt makes any noise while you are torquing it, loosen the bolt and retorque it from the first step.
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.

Warpage
Service Limit 0.05 mm (0.002 in.)
Height
Standard or New 120.95-121.05 mm (4.762-4.766 in.)


Intake Manifold





Install the intake manifold. Tighten the bolts and nuts sequentially in two or three steps.


Camshaft Pulley